Table Top Tilt Stand

Introduction

This kit provides a Table Top Tilt Stand for the P1532 POS (7734).

Kit Content

 

 

 

 

Installation Procedure

1.Place the Table Top Tilt Stand on top of the display assembly.

2.Secure the Table Top Tilt Stand with M4 x 30 screws (4).

Installing the Power Supply

Caution:  The P1532 terminal requires the NCR 19 V or 24 V power supply that is shipped with the terminal. Use of other power supply may cause damage to the unit. Do not connect or disconnect the 19 V or 24 V Power Cable from the terminal with the AC Power Cord still connected to an AC outlet.

To install the 19V power supply inside the P1532 terminal, follow these steps:

1.Pivot the display toward the back.

2.Attach the AC power cord to the power brick.

3.Open the CableLock™ Cover.

4.Slide and install the power brick to the base. Ensure that the power brick's label is facing down.

5.Route the AC power cord to the right of the power brick and then down the opening at the base of the terminal.

6.Route the power cable up the stand and connect to the Power In port.

7.Close the CableLock Cover and tighten thumbscrew to secure cover.

8.Connect the AC power cord to an AC outlet.